2:5 - The 2:5 format has a resolution of 0.01 mil.2:4 - The 2:4 format has a resolution of 0.1 mil.2:3 - The 2:3 format has a resolution of 1 mil (1/1000 inch).Format- The format specifies the precision of the coordinate data, which must be selected to suit the placement precision of the objects in the PCB workspace.Millimeters - Check this option to use millimeters as unit.Inches - Check this option to use inches as unit.Units- The units can be either inches or millimeters.In the case of the former, the settings are stored in the project file, whereas for the latter they are stored in the Output Job Configuration file. Note : The settings defined in the Gerber Setup dialog when generating output directly from the PCB are distinct and separate to those defined for the same output type in an Output Job Configuration file. Output will be generated immediately upon clicking OK in the Gerber Setup dialog. Directly from within the active PCB document using the File » Fabrication Outputs » Gerber Files menu command.
#Altium designer pcb mirror generator
Output is generated when the configured output generator is run. Using a Gerber output generator in an OutputJob Configuration file (*.OutJob).Gerber output can be generated in one of two ways: The Gerber Setup dialog provides you with tools to completely configure your Gerber file output options. It is advisable to consult with your board fabricator to confirm their requirements before supplying the output documentation required to fabricate your design. Parent page: WorkspaceManager Dialogs SummaryĮach Gerber file corresponds to one layer in the physical board – the component overlay, top signal layer, bottom signal layer, the solder masking layers and so on.
0 kommentar(er)
